Filter
Top Products
2 • HP All-in-One
5
4
Attach the control panel faceplate (if not attached)
Attach paper trays and load paper
a Align the control panel faceplate with the device.
b Press down fi rmly on all edges of the faceplate until
it snaps into place . Verify that the corners and the
bottom edge are attached. Make sure the buttons
are accessible.
IMPORTANT: The control panel faceplate must be
attached for the HP All-in-One to work!
a Insert the bottom tray into the device.
b Slide the paper adjuster over to the left.
c Insert plain white paper. Move the paper adjuster
to the edge of the paper.
d Attach the top (output) tray. Make sure you hook the
top edge of the tray into the light gray latches, and
then lower.
e Pull out and fl ip over the tray extender.
a
b
a
b
c
d
e