Filter
Top Products
Removal and replacement procedures 33
5.
Disconnect the SATA and power cables from the optical drive.
6. Remove the optical drive.
To replace the component, reverse the removal procedure.
Drive cage
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the tower bezel (on page 26).
4. Remove the access panel ("Access panel" on page 31).
5. If the drives are connected to a storage controller card, remove the air baffle.
6. Remove all installed drives ("Storage drive" on page 28).
7. Disconnect the drive cage cables:
a. Disconnect the Mini-SAS cable from the system board or from the storage controller option.
b. Disconnect the drive power cable from the 10-pin power supply connector.
8. Remove the drive cage: