Filter
Top Products
IU 661 / 0047 7 TowerFeed
TM
for the HP LaserJet 8150/8100/8000
INSTALLATION
Hardware Installation
Warning:
POWER OFF your printer and TowerFeed and disconnect all power and interface cables before you
proceed with the installation.
Remove Transportation Inserts
• Pull out, lift upwards and remove the trays from TowerFeed.
Remove the transportation inserts (Fig. 8). There are two at
each side (keep the inserts for reshipment).
• Re-insert and close the trays.
Note:
Located on the right side of each tray you will find coding
pins for the paper size. They are set by the factory and must
not be changed.
Position and Connect Printer
Warning:
The printer may weigh up to 53 kilograms (120 pounds). Enlist the
help of a second person to lift the unit. To prevent back strain or
injury, bend your knees when lifting the unit.
• Place the TowerFeed unit at the location you wish. Be sure to
place it on a flat location.
• Pull the feeder adapter open and carefully lift the laser printer
onto TowerFeed. Place its positioning holes on the positioning
pegs of the TowerFeed top (Fig. 9).
Be careful to not damage the paper feeding adapter.
Caution:
To lift the printer use one hand for the left hand holds and the
other hand to hold the printer at its right side.
• Do not use the handholds on the right side of the printer.
Fig. 8 Removing Transportation Inserts
Fig. 9 Positioning the Printer and
Location of the Power Switch