Filter
Top Products
Loading media in the optional
tray 4
Note
Before loading media into tray 4, verify
that the spacers were removed from the
tray when “Step 2: Unpacking the Printer”
was performed.
1 Firmly grip the handle in the center of
the input tray, squeeze the release
lever, and pull the tray out until it
stops.
Depending on your country, tray 4 arrives
adjusted for either A4- or letter- sized
media. To load A4- or letter-sized media,
proceed to step 5; otherwise, continue
with step 2.
2 Adjust the front guide by pulling up
on the pin (A), placing the guide into
the slots on the top and bottom of the
tray that correspond to the media size
you are loading (B), and pushing in
the pin.
3 Repeat step 2 to adjust the back
guide.
4 Repeat step 2 to adjust the left media
guide.
Note
To load 11-by-17 inch media, rotate the
left media guide 90°, move it to the back
of the tray, and place it into the slots on
the top and bottom of the tray that
correspond to 11-by-17.
28 Step 7: Loading the Input Trays EN