Filter
Top Products
EN
Step 3: Installing the Cables
13
9
Roll the printer to its permanent
location, where all four wheels rest on
a level floor surface, and stabilize it by
pushing the locking tabs on the tray's
wheels to the locked position.
10
Rotate the feet of the five stabilizing
legs and the anti-tip foot (on the left
side of the tray) until they are snug
against the floor.
WARNING!
An unstable printer can tip over and
cause injury; make sure that the printer
is secured properly.
11
Plug the male end of the power cord
into a surge protector or other
grounded power source.
Note
If an optional output device was ordered,
see the installation guide included with
the output device for installation
instructions.