Filter
Top Products
Removal and replacement procedures 30
To replace the component:
1.
Install the mezzanine card. Press down above the back side of the connector to seat the card.
2.
Install the access panel ("Access panel" on page 24).
3.
Install the server blade.
HP Smart Array E200i Controller cache module
To remove the component:
1.
Power down the server blade (on page 23).
2.
Remove the server blade (on page 23).
3.
Remove the access panel ("Access panel" on page 24).
4.
Remove all hard drives ("Hard drive" on page 25).
5.
Remove all hard drive blanks ("Hard drive blank" on page 24).
6.
Remove the hard drive backplane ("Hard drive backplane" on page 28).
7.
Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on
page 28).
8.
Remove the USB key, if any ("System board components" on page 58).