Filter
Top Products
Component replacement procedures
This chapter provides removal and replacement procedures.
There are as many as 77 screws that must be removed, replaced, or loosened when servicing
the computer. Make special note of each screw size and location during removal and replacement.
Display panel
Description Spare part number
14.0 in, WLED, BrightView SVA display panel
In black finish for use with touch models only 699378-001
716398-001
In black finish for use with non-touch models only 702683-001
716399-001
In black and silver finish for use with non-touch models only 702684-001
716400-001
Before removing the display panel, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
Remove the display panel:
1. Turn the computer right-side up, with the rear toward you.
2. Open the computer.
3. Remove the 2 screw covers (1) on the left and right side base of the display panel.
NOTE: Use a sharp probe to pop the covers out to avoid scratching the bezel
4. Remove the 2 Phillips PM 2.5x3 screws (2) on the left and right hinges that secure the display
panel to the computer.
NOTE: Support the display panel as you are removing the screws.
5. Loosen the edges of the plastic bezel cover (3) from all four sides of the display panel.
Component replacement procedures 39