Filter
Top Products
B-4 ENWW
AUTO-DUPLEX UNIT NOT
AVAILABLE PRESS
RESUME OR CANCEL
The auto-duplex unit comes
with the CP1700D model. You
can also purchase it as an
optional accessory. If you
have not purchased the auto-
duplex unit, you cannot print
an auto-duplex job.
If you have purchased the
auto-duplex unit, make sure it
is installed correctly in the
printer. Otherwise, press the
RESUME button to continue
the job using single-sided
printing, or press the
CANCEL button to cancel the
job.
REINSERT [number]
PAGES INTO [TRAY ]
This message is for manual
duplexing. Indicates that
printing on the first side of the
media is complete.
Take the printed stack of
paper from the output tray and
put it back into the specified
tray.
ROTATE AND REINSERT
[number] PAGES INTO
[TRAY]
This message is for manual
duplexing. Indicates that
printing on the first side of the
media is complete.
Take the printed pages from
output tray, rotate the stack
180 degree horizontally and
put it back to the specified
tray
.
PRINTHEAD ACCESS
LATCH OPEN
The printhead access latch is
open.
Open the printhead cover,
close the printhead access
latch, and then close the
printhead cover. You will have
to use some force to close the
printhead access latch. If the
printhead access latch will not
close, ensure that the
printheads are seated properly
by pushing down firmly on
each printhead.
REAR ACCESS PANEL
OPEN
The rear access panel is not
installed correctly or at all in
the printer.
Make sure the rear access
panel is inserted correctly and
completely into the printer.
LANGUAGE=
[LANGUAGE]
Displays the language in
which the LCD shows
messages.
For information about
changing the display
language, see “Setting the
LCD language.”
Message Explanation Recommended Action
EulerUG.book Page 4 Monday, July 16, 2001 5:34 PM