Filter
Top Products
3.
Release the TouchPad board ZIF connector (2) to which the TouchPad button board cable is
connected, and then disconnect the cable from the TouchPad board.
4. Remove the two Phillips PM2.5×3.5 screws (1) that secure the TouchPad button board bracket to
the top cover.
5. Lift the rear edge of the TouchPad button board bracket (2) until it rests at an angle.
6. Slide the TouchPad button board bracket (3) up and away from the top cover until the tabs (4) on
the front edge of the bracket disengage from the top cover.
74 Chapter 4 Removal and replacement procedures