Filter
Top Products
NOTE:
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid
configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on CTO product offerings and requirements.
NOTE:
HP does not allow factory integration of options into standard models listed above. Configure-to-order servers must
start with a CTO Chassis.
NOTE:
FIO indicates that this option is only available as a Factory Installable Option.
Step 1: Base Configuration
Non-Hot Plug SATA Model (choose one of the following configurable
models)
HP DL165G7 NHP CTO Chassis
591660-B21
Factory Integrated Model ships with:
Two HP NC362i Integrated Dual Port Gigabit Server Adapters
Slot 1: FL /FH PCI-Express x16 Gen 2 slot or
Slot 1 : HL/FH x16 PCI-Express Gen2 slot and
Slot 2 : HL/LP x8 PCI-Express Gen2 slot (internal only)
HP Smart Array B110i SATA RAID Controller
One Highline IEC Power Cord
4 Fixed, Non-Redundant Fans (standard); 6 Fixed, N+1 Redundant Fans
(standard with addition of second processor)
Rack (1U), (1.75 in / 4.45 cm)
Tool-less Fixed Rails
Hot Plug/Cold Plug Models
HP DL165G7 LFF CTO Chassis
592226-B21
HP DL165G7 SFF CTO Chassis
592227-B21
Factory Integrated Model ships with:
Two HP NC362i Integrated Dual Port Gigabit Server Adapters
Slot 1: FL /FH PCI-Express x16 Gen 2 slot or
Slot 1 : HL/FH x16 PCI-Express Gen2 slot and
Slot 2 : HL/LP x8 PCI-Express Gen2 slot (internal only)
One Highline IEC Power Cord
4 Fixed, Non-Redundant Fans (standard); 6 Fixed, N+1 Redundant Fans
(standard with addition of second processor)
Rack (1U), (1.75 in / 4.45 cm)
Tool-less Fixed Rails
QuickSpecs
HP ProLiant DL165 Generation 7
Configuration Information - Factory Integrated Models
DA - 13602 Worldwide QuickSpecs — Version 2 — 4.2.2010
Page 13