Filter
Top Products
Installing the switch 24
Installing XFP transceivers
CAUTION: To prevent damage to the fiber optic cable or the XFP transceiver, do not install or
remove fiber-optic XFP transceivers with cables attached. Disconnect all cables from the XFP
transceiver before removing or installing an XFP transceiver.
CAUTION: Removing and installing an XFP transceiver can shorten the useful life. Do not
remove and insert XFP transceivers more often than is necessary.
CAUTION: HP recommends attaching an ESD-preventative wrist strap to your wrist and to a
bare metal surface on the chassis to prevent electrostatic discharge.
CAUTION: Do not remove the dust plugs from the fiber-optic XFP transceiver or the rubber caps
from the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect
the XFP transceiver ports and cables from contamination and ambient light.
1. Remove the dust plug and save for future use.
IMPORTANT: Use only XFP transceivers purchased from HP.
2. Insert the XFP transceiver. With latch closed, be sure that the transceiver is fully seated and securely
in place.
Supporting software and special considerations
Supporting software is available to assist in configuring and managing the switch.
• Server Blade and Power Management Module Firmware—Provides firmware and installation
instructions required for proper rack location operation.
• Utilities package and documentation—Provides utilities and documentation for switch management.