HP (Hewlett-Packard) Ethernet BL-c Switch Switch User Manual


 
Introduction 9
A text-based, human read/write configuration file provides viewing, printing, and editing
capabilities.
A DNS client supports primary and secondary DNS servers.
Any port can be enabled or disabled as desired.
Any switch port can be used to perform switch management and PXE.
Diagnostic tools
The hardware, software, and firmware diagnostic tools that are available include:
HP Systems Insight Manager automatic discovery and identification
POST built into the switch boot process
Switch port mirroring
Switch LED panel displaying per port status and speed
System, management, and option compatibility status LEDs
Rear panel reset power switch and DB-9 management serial port
Statistic monitoring including port utilization, data packets received/transmitted, port error packets,
trunk utilization, and so on
Ping and trace route capability
Remote syslog with support for primary and secondary syslog server
The ability to return the switch to known good condition in case of firmware corruption
State information dump for tuning and debugging switch performance
Panic command for immediate state dump to flash memory and automatic switch boot
Ability to set NVRAM diagnostic flags
Switch architecture
The HP c-Class BladeSystem provides Ethernet switching technology for network cable reduction.
The switch does not affect or determine NIC enumeration and the associated mapping of NIC interfaces
to switch ports. The numbering of the NICs on the server (for example, NIC 1, NIC 2, NIC 3) is
determined by the server type, the server operating system, and what NICs are enabled on the server.
Port Mapping
For detailed port mapping information, see the HP BladeSystem enclosure installation poster or the HP
BladeSystem enclosure setup and installation guide on the HP website
(http://www.hp.com/go/bladesystem/documentation
).
Dual switches
In a dual switch configuration, two switches in the server blade enclosure provide switch redundancy and
redundant paths to the network ports on the server blades. Each switch has four, one Gigabit and three,