HP (Hewlett-Packard) FN023UAABA Laptop User Manual


 
Select To do this
TPM Embedded Security
(requires an administrator
password)
Change TPM (Trusted Platform Module) Embedded Security device state at restart.
The following options are available:
Do Nothing (enabled by default)
Available and Disabled
Available and Enabled
Factory Defaults
Reset Authentication Credential.
Enable/disable support for the following:
Power-on authentication support (enabled by default)
Operating system TPM management (enabled by default)
Reset of TPM from operating system (disabled by default)
Disk Sanitizer Run Disk Sanitizer to destroy all existing data on the primary hard drive.
CAUTION: If you run Disk Sanitizer, the data on the primary hard drive is destroyed
permanently.
System IDs Enter a user-defined computer asset tracking number and ownership tag.
Diagnostics menu
Select To do this
System Diagnostics menu
F1 System Information—Displays the following information:
Identification information for the computer and the batteries in the system.
Specification information for the processor, cache and memory size, system
ROM, video revision, and keyboard controller version.
F2 Start-up Test—Verifies the system components needed for starting the computer.
F3 Run-In Test—Runs a comprehensive check on system memory.
F4 Hard Disk Test—Runs a comprehensive self-test on any hard drive in the
system.
System Configuration menu
NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
106 Chapter 5 Computer Setup