Filter
Top Products
e. Display assembly (see Display assembly on page 75)
f. Top cover (see
Top cover on page 81)
g. ExpressCard board (see
ExpressCard board on page 84)
Remove the audio board:
1. Remove the three Phillips PM2.5×5.0 screws (1) that secure the audio board to the system board.
NOTE: The audio board cable ground loop (2) is secured by the audio board rear screw.
2. Disconnect the speaker cable (3) from the audio board.
3. Disconnect the audio board cable (4) from the system board.
4. Release the audio board (1) by sliding it up and away from the front edge of the base enclosure.
5. Disconnect the microphone cable (2) from the audio board.
86 Chapter 4 Removal and replacement procedures