HP (Hewlett-Packard) G7 Laptop User Manual


 
5.
Lift the rear edge of the TouchPad button board (6) until it is released from the clips built into
the top cover.
6. Remove the TouchPad button board and cable.
Reverse this procedure to install the TouchPad button board and cable.
TouchPad LED board
Description Spare part number
TouchPad LED board (includes cable) 640213-001
Before removing the TouchPad LED board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 47), and then remove the following components:
Optical drive (see
Optical drive on page 49)
Hard drive (see
Hard drive on page 51)
Keyboard (see
Keyboard on page 57)
Top cover (see
Top cover on page 61)
Component replacement procedures
67