Filter
Top Products
Solid-state drive
Description Spare part number
256-GB SATA III solid-state drive 698645-001
128-GB SATA III solid-state drive 697235-001
128-GB SATA II solid-state drive 675508-001
Before removing the solid-state drive and cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 33).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (2) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
2. Remove the solid-state drive by pulling the drive away from the slot at an angle (2).
NOTE: The solid-state drive is designed with a notch to prevent incorrect installation into
the solid-state drive slot.
Component replacement procedures
35