Filter
Top Products
Wireless audio module
Description Spare part number
Wireless audio module 672011-001
Before removing the wireless audio module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 33), and then remove the following components:
a. Solid-state drive connector board cable (see
Solid-state drive on page 35)
b. Card Reader board cable (see
Card Reader board cable on page 37)
c. Top cover (see
Top cover on page 40)
Remove the wireless audio module:
1. Disconnect the wireless audio module antenna cables (1) from the terminals on the wireless
audio module.
NOTE: The #7 wireless audio module antenna cable is connected to the wireless audio module
“Main” terminal. The #8 wireless audio module antenna cable is connected to the wireless
audio module “Aux” terminal.
2.
Remove the Phillips PM2.0×3.8 screw (2) that secures the wireless audio module to
the system board. (The wireless audio module tilts up.)
Component replacement procedures
51