Filter
Top Products
IU 675 / 0150 9 TowerFeed
TM
for the HP LaserJet 9000
INSTALLATION
Blocking (De-blocking) the Guiding Bar in horizontal position
The stand has a provision for blocking the guiding bar so that the
output stacker, after being pulled back from the printer for jam
removal, can be pushed back easily and without risk to tip over.
• To activate the blocking mechanism, push the bolt into the
guiding bar and fix it in position with the knurled screw (Fig. 18).
Attaching the Output Stacker to the Printer
• Insert the guiding bar of the stand into the guide holder that is on
the rear lower side of TowerFeed (Fig. 19).
• Slide-in the blue plastics guide until it snaps into position (Fig.
20).
• Push the stand with the output stacker towards the printer system
until the stacker's spring-loaded hooks snap into the printer's
cutouts.
• Adjust the output stacker inclination using the two blue
adjustment wheels of the outside stacker rollers (Fig. 21, Fig.
22a+b) until the output stacker is parallel to the printer (Fig. 22c)
• Adjust clamp and tighten its screw (Fig. 22d)
Fig. 18
Fig. 19
Fig. 20
Fig. 21
a
b
c
Fig. 22
d