Filter
Top Products
Hardware options installation 18
Removable media device option (ML110 G6 servers)
This process only represents one installation method. For instructions for installing the media device into a
specific server, see the installation sheet that ships with the server or the HP website
(http://www.hp.com/go/bizsupport).
To install the component:
1. Power down the server (on page 7).
2. Extend the server from the rack.
3. Remove the access panel (on page 7).
4. Remove the tower bezel ("Remove the tower bezel (ML110 G6 servers)" on page 8).
5. Using a Phillips screwdriver, press the release tab on the bezel blank, then remove the shield.
HP recommends that you remove all bezel blanks to facilitate drive installation.
6. Install the four screws into the top screw holes on the media device.
7. Slide the media device part into the bay.