Filter
Top Products
OS Support
Microsoft Windows Server 2000
Microsoft Windows Server 2003 R2
Microsoft Windows Small Business Server 2003 R2
Microsoft Windows Server 2008
Microsoft Windows Server 2008 Hyper-V
Microsoft Windows Small Business Server 2008 and Microsoft Windows Essential Server 2008
Oracle Enterprise Linux (OEL)
Red Hat Enterprise Linux
SUSE Linux Enterprise Server
Novell NetWare
SCO OpenServer
SCO UnixWare
VMware
Citrix XenServer
NOTE:
For more information on HP's Certified and Supported ProLiant Servers for OS and
Virtualization Software and latest listing of software drivers available for your server, please visit
our Support Matrix at:
http://www.hp.com/go/supportos
and our driver download page
http://www.hp.com/support/ML370G5
Rack Airflow
Requirements
Rack 10000 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 Series Racks provide enhanced airflow for
maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION:
If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:
Front and rear doors:
If your 42U server rack includes closing front and rear doors, you must
allow 830 square inches (5,350 sq cm) of hole evenly distributed from top to bottom to
permit adequate airflow (equivalent to the required 64 percent open area for ventilation).
Side:
The clearance between the installed rack component and the side panels of the rack
must be a minimum of 2.75 inches (7 cm).
CAUTION:
Always use blanking panels to fill all remaining empty front panel U-spaces in the rack.
This arrangement ensures proper airflow. Using a rack without blanking panels results in improper
cooling that can lead to thermal damage.
NOTE:
For additional information, refer to the Setup and Installation Guide or the Documentation
CD provided with the server, or to the server documentation located in the Support section at the
following URL:
www.hp.com/servers/ml370
.
Installation of HP
ProLiant ML370 G5
servers with Round
Hole, Third Party or
Telco Racks
ProLiant rack mount servers and tower-to-rack kits include snap-on quick deploy side rails
designed to accommodate both round and square hole rack rails. Telco rack solutions for ProLiant
servers are available through the following URL:
http://www.racksolutions.com/hp
.
QuickSpecs
HP ProLiant ML370 Generation 5
Standard Features
DA - 12478 U.S. QuickSpecs — Version 41 — 1/26/2009
Page 14