Filter
Top Products
Removal and Replacement Procedures
Maintenance and Service Guide 5–47
2. Position the computer with the rear panel toward you.
3. Release the ZIF connector to which the USB/audio board
cable is connected and disconnect the USB/audio
board cable 1 from the system board.
4. Remove the Phillips PM2.0×3.0 screw 2 that secures the
USB/audio board to the base enclosure.
5. Remove the cable from the clips 3 in the base enclosure.
6. Remove the USB/audio board 4.
7. Release the ZIF connector to which the USB/audio board
cable is connected and disconnect the USB/audio
board cable 5 USB/audio board.
Removing the USB/Audio Board
Reverse the above procedure to install the USB/audio board.