Filter
Top Products
1 Connecting to a Netware 3.12 Server
Windows for Workgroups Version 3.11
listed above under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the Intel drivers diskette, insert Netware client for DOS
and MS-Windows disk 1.
8 Execute INST_DOS.EXE. If you are using a Vectra VL8, enter yes to
accept the agreement and then continue from step 9.
If you are using a Vectra VL7 or VE8, follow the steps below and then
continue from step 16.
a Specify the settings as listed below:
• C:\NWCLIENT
•Yes
•Yes
• C:\WINDOWS
•No
• Intel Etherexpress ™ PRO/10 LAN Adapter
b Under the heading "Select the driver for your network board", insert
the Intel Etherexpress ™ PRO/10 drivers disk and set the path to
"A:\DOS\." (If you have an HP preloaded HDD, set path to "C:\Mas-
ters\LanDrv\PRO10P\DOS\)
c Press "Enter" to continue the installation.
9 Accept the default products by pressing enter, and then press “F10” to
continue.
10 Select 16-bit LAN Drivers and hit the enter key.
11 Page down the Board Drivers list to “USER SPECIFIED 16 BIT DRIVER”
and hit enter.
12 Insert the Intel ethernet drivers diskette, set the path to “A:\DOS\” and
press enter.
13 Select “Intel EtherExpress ™ PRO/10” and press enter.
14 Accept the default settings, press “F10” to continue, and verify the
following entries for the “Installation Configuration Summary”:
❒ YES