Filter
Top Products
Daytona Twin Tec LLC, 933 Beville Road, Suite 101-H, S. Daytona, FL 32119 TCFI Log
(386) 304-0700 www.daytona-twintec.com
3/2007
Page 5
Figure 2 – Data Logging Chart Display
The following additional functions are available
from the Edit menu:
BLM Cell Display – shows the active cell in
terms of RPM and TPS percent at the cursor
position. TPS percent is compensated for idle
air. This function is useful for determining what
fuel table cell is active at any given point in time.
Gear Ratio Display – shows the calculated gear
ratio (RPM/KPH) at the cursor position. This
function is useful for determining the 6th gear
ratio required for Module Parameter setup in PC
Link TCFI IID for 2007 models with six speed
transmissions and a 6th gear indicator light.
Units Selection – allows selection of MPH or
KPH units for vehicle speed display.
IAC MANUAL OVERRIDE
The IAC Manual Override command on the
Communications menu allows you to manually override
the idle air control stepper motor position while the
engine is running. This command is primarily used to
calibrate larger aftermarket throttle bodies, but can also
be used as a diagnostic aid.