Filter
Top Products
2 Connecting to a Netware 4.11 Server
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2 installed.
• Intel EtherExpress Pro 10+ ISA Ethernet card and drivers disk Ver. 3.5.
• Vectra VL8 and VE7/VE8 Driver Name: NETPRO.INF Size: 12KB Date:
4/25/97
• Vectra VL7 Driver Name: EPRO.SYS Size:11KB Date: 6/3/97
• Novell Netware 3.12 server that supports Net BEUI,TCP/IP, NWLink IPX/
SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Board Connector type Auto-detect
• Force 8-bit operation Yes
• Flash chip address Disabled
• Remote boot program None
Procedure
1 With the HP Vectra turned off, install the Intel EtherExpress Pro10+ ISA
adapter card into an ISA slot.
2 Connect network Cable media to the Intel EtherExpress ISA card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the Intel EtherExpress drivers disk, “EtherExpress
drivers Ver. 3.5” and execute “A:\SOFTSET2.EXE.”
5 Select “Configure NIC”, and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the Intel EtherExpress software driver diskette and reboot the
machine.
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Address 210-21Fh 210-21Fh 300-30Fh
Interrupt 10 10 11