Filter
Top Products
4 Connecting to a Windows NT Server 4.0
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2.
• Intel EtherExpress PRO 10+ ISA Ethernet card and drivers disk.
• Driver Name: PROW95.VXD Size: 6K Date: 8/7/96
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI,TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Board Connector type Auto-detect
• Force 8-bit operation Yes
• Flash chip address Disabled
• Remote boot program None
Procedure
1 With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA
adapter card into an ISA slot.
2 Connect network cable media to the Intel EtherExpress PRO 10+ ISA
card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the Intel EtherExpress drivers disk, “EtherExpress
drivers Ver. 3.5”, and execute “A:\SOFTSET2.EXE.”
5 Select “Configure NIC”, and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the Intel EtherExpress software driver diskette and reboot the
machine.
8 Power on the machine and allow it to boot to Windows 95.
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Address 210-21Fh 210-21Fh 300-30Fh
Interrupt 10 10 11 (16 bit only)