Filter
Top Products
5-7
Configuring IP Addressing, Interface Access, and System Information
IP Configuration
Configuring IP Addressing,
Interface Access, and
6. If you selected Manual , press [Tab] or [v], and additional fields will be
displayed for entering the IP address for the Timep server.
7. Select the TimeP Poll Interval field if you want to change the value for how
often the switch polls the Timep server for time information.
8. Do one of the following:
• If you want to have the switch retrieve its IP configuration from a
DHCP or Bootp server, at the IP Config field, keep the value as DHCP/
Bootp and go to step 11.
• If you want to manually configure the IP information, use the Space
bar to select Manual and use the [Tab] key to move to the other IP
configuration fields.
9. Select the IP Address field and enter the IP address for the switch.
10. Select the Subnet Mask field and enter the subnet mask for the IP address.
11. Press [Enter], then [S] (for S
ave).
CLI: Configuring IP Address, Gateway, Time-To-Live
(TTL), and Timep
IP Commands Used in This Section
For a listing of the full CLI command set, including syntax and options, see
the CLI command reference available on the HP ProCurve website at:
http://www.hp.com/go/procurve
show ip page 5-8
vlan <vlan-id> ip
address
page 5-9
ip default-gateway page 5-9
ip ttl page 5-9
[no] ip timep page 5-10