Filter
Top Products
Digital media card reader board
Description Spare part number
Digital media card reader 702359-001
Before removing the digital media card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
Base enclosure on page 28).
5. Disconnect the battery cable (see
Battery on page 29).
Remove the digital media card reader board and bracket:
1. Disconnect the digital media card reader cable (1).
2. Remove the 2x2–mm broadhead screw on the rear edge of the board and then remove the 2
2x5–mm screws securing the digital media card reader board to the system board (2). The drive
tilts upwards.
3. Remove the digital media card reader board and bracket (3).
Reverse these procedures to reassemble and install the digital media card reader board.
Component replacement procedures 31