Filter
Top Products
USB/Power Connector board
Description Spare part number
USB/Power Connector board 702360-001
Before removing the USB/Power connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
Base enclosure on page 28).
5. Disconnect the battery cable (see
Battery on page 29).
Remove the USB/Power connector board:
1. Disconnect the USB/Power connector board cable (1).
2. Remove the 3 screws securing the USB/Power connector (2).
3. Remove the USB/Power connector board (3).
Reverse this procedure to install the USB/Power connector board and cable.
32 Chapter 4 Removal and replacement procedures