Filter
Top Products
36 Removing and Replacing Parts ze1000 Series Troubleshooting and Self-Repair Guide
Figure 9. Removing the Hard Disk Tray
Reassembly Notes
• Insert the connector end of the drive through the opening in the carrier, then lower the drive into
place.
• Carefully slide the new drive into the hard drive compartment. Press firmly to make sure its
connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the
drive before loading any additional software—see “Recovering the Factory Software Installation”
on page 33.
Screws,
M2.5x4mm (2)
Screws,
M2.5x4mm (2)