Filter
Top Products
ze1000 Series Troubleshooting and Self-Repair Guide Removing and Replacing Parts 37
Removing an SDRAM Module
The notebook has no SDRAM built into its motherboard, but has two slots for removable SDRAM
modules in a compartment on the bottom of the unit. (One of these slots contains a module installed at
the factory). You can use these slots to expand your unit’s RAM. Use HP PC133 SDRAM modules
only, or your notebook will not boot up.
Table 3. SDRAM Module Replacement Part Numbers
Description Part Number Exchange Part Number
Module, SDRAM, 128 MB, PC133 SODIMM (X16) 1818-8504
Module, SDRAM, 256 MB, PC133 SODIMM (X16) 1818-8635
Module, SDRAM, 256 MB, PC133 SODIMM (X8) 1818-8604 F2298-69001
Caution
Provide proper grounding and handle the SDRAM module only by its edges, or you could
damage the module through electrostatic discharge.
Required Equipment
• #0 Phillips screwdriver.
Removal Procedure
1. Turn off the notebook: click Start, Turn Off Computer, Turn Off.
2. Important: Unplug the AC adapter (if present) and remove the notebook’s battery.
3. On the bottom of the notebook, loosen the screw holding the RAM cover (the cover retains the
screw), and remove the cover.
4. Release the two latches at the sides of the SDRAM module by pushing them gently outward
(away from the sides of the module). When you release the latches, the free edge of the module
pops up.