Filter
Top Products
THE REMOTE CONTROL
22
HOW TO USE THE REMOTE TO
CONTROL YOUR TV
ቧ CHANNEL selector b
uttons
CHANNEL selector buttons are used to select channels, lock access code, etc.
Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (
̆) or down (̄).
ቨ ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.
NOTE: The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 41).
Ant B 28
Ant A 10
ANT
ቩ VID1 ~ VID5
When the remote control is in TV mode, press these buttons to directly select the video input sources between the five video inputs.
When the remote control is in DVD/VCR mode, these buttons will control the DVD or VCR, and execute the secondary function
labeled.
ቦ VOLUME, MUTE button
Press the
VOLUME up (
̆) or do
wn (
̄) b
utton until you obtain the desired sound level.
To reduce the sound to one half the normal volume (SOFT MUTE), press the MUTE button. Press the MUTE button again to turn
the sound off completely (MUTE). To restore the sound, press the MUTE button one more time, or press the VOLUME Up (
̆) but-
ton.
Closed Captioning will display when MUTE/SOFT MUTE is on and Closed Caption is set to AUTO (See page 58).
▲
▲
V
olume 8
▲
▲
Mute 8
▲
▲
Soft Mute 8
MUTE
MUTE