Filter
Top Products
30
1.8 Confirming the connection to your destination
When the network connection is established,
the “Connection to Projector successful” screen
is displayed.
Make sure that the right projector that you want
to send your image to is selected, by checking
the projector name and IP address shown in
the screen.
1.8.1 Connection and transmission
•
To send images to the projector, click the [Yes]. The transmission will be started.
To display the transmitted images, select the LAN port as input source on the
projector.
• Not to send, click
the
[No], then the “LiveViewer” main menu is displayed
in stand-by mode. (Stand-by mode is the state where there is no image
transmission, although the network connection is established.)
The transmission can be started, if you click or button on the “LiveViewer”
main menu.
[Troubleshooting]
The projector you want to send your images
to is occupied by another computer in the
Presenter mode.
Click
the
[OK], then the “LiveViewer” main
menu is displayed in stand-by mode. Retry
to send your images, after the Presenter
mode is off.
This projector is currently in use (Presenting) by another user.
If you wish to use the current connection setting as a prole data for My
Connection, check in the box for
the
[Register this setting to My Connection].
1. Connection to the network