Filter
Top Products
Basic operations (continued)
Turning off the power]
2
1
P _nP MUTE
BLANK AUTO TIMER
1
Press the STANDBY/ON button for approximately 1 sec.
• The Power indicator wilt blink orange, then the lamp wilt turn off. Approximately 1 sec. after that, the
lamp will light orange.
• After the power is turned off, the lamp will be cooled for approximately 1 min. and the power cannot
be turned off even by pressing the STANDBY/ON button.
• The standby status wilt not be entered if the time which the STANDBY/ON button is pressed is too
short.
2 Turn off the main power switch of the projector [ _ : OFF].
3 Attach the lens cap.
(Caution-) The fan will continue nmning for approximately 1 min. after the STANDBY/ON button is pressed.
Do not turn offthe main power switch while the lamp is on because this will shorten the service life of
the lamp.
Plug & Play
This projector is VESA DDC 1/2B compatible. Plug & play is possible by connecting to a computer that is
VESA DDC (Display Data Channel) compatible.
(Plug & play is a system configured with peripheral equipment including a computer and display, and an
operating system.
7
[Caution') Use the RGB cable included with this projector when using plug & play. With other cables, pins ]
(12) - (15) are sometimes not connected (effective only for RGB).
J
14