Filter
Top Products
5K320 SATA OEM Specification
153
Activity
ointer
ability
ability
ability
15
Th
e self-test routine in progress
14.40.2.5 Total Time in Seconds to Complete Off-line Data
Collection
This field tells the host how many seconds the device requires to complete the off-line data collection
activity.
14.40.2.6 Current Segment P
This byte is a counter indicating the next segment to execute as an off-line data collection activity.
Because the number of segments is 1, 01h is always returned in this field.
14.40.2.7 Off-Line Data Collection Cap
Bit Definition
0
Execute Off-line Immediate implemented bit
0
S.M.A.R.T. Execute Off-line Immediate subcommand is not implemented
1
S.M.A.R.T. Execute Off-line Immediate subcommand is implemented
1
Enable/disable Automatic Off-line implemented bit
0
S.M.A.R.T. Enable/disable Automatic Off-line subcommand is not implemented
1
S.M.A.R.T. Enable/disable Automatic Off-line subcommand is implemented
2
abort/restart off-line by host bit
0
The device will suspend off-line data collection activity after an interrupting command and resume
it after some vendor specific event
1
The device will abort off-line data collection activity upon receipt of a new command
3
Off-line Read Scanning implemented bit
0
The device does not support Off-line Read Scanning
1
The device supports Off-line Read Scanning
4
Self-test implemented bit
0
Self-test routine is not implemented
1
Self-test routine is implemented
5
Reserved (0)
6
Selective self-test implemented bit
0
Selective self-test routine is not implemented
1
Selective self-test routine is implemented
7
Reserved (0)
14.40.2.8 S.M.A.R.T. Cap
This word of bit flags describes the S.M.A.R.T. capabilities of the device. The device will return 03h
indicating that the device will save its Attribute Values prior to going into a power saving mode and
supports the S.M.A.R.T. ENABLE/DISABLE ATTRIBUTE AUTOSAVE command.
Bit Definition
0
Pre-power mode attribute saving capability
If bit = 1, the device will save its Attribute Values prior to going into a power saving
mode (Standby or Sleep mode).
1
Attribute autosave capability
If bit = 1, the device supports the S.M.A.R.T. ENABLE/DISABLE ATTRIBUTE AUTOSAVE
command.
2-15
Reserved (0)
14.40.2.9 Error Logging Cap
Bit Definition
7-1
Reserved (0)
0
Error Logging support bit
If bit = 1, the device supports the Error Logging
14.40.2.10 Self-test failure check point
This byte indicates the section of self-test where the device detected a failure.