Hitachi MK-97DF8018-00 Computer Drive User Manual


 
A–8 Operations Using CLI
Hitachi Simple Modular Storage Copy-on-Write SnapShot User’s Guide
Changing Pair Information
You can change the pair name, group name, and/or copy pace.
1. From the command prompt, register the subsystem to which you want
to change the SnapShot pair information, then connect to the
subsystem.
2. Execute the aureplicationlocal command change the pair
information. This is an example of changing a copy pace.
The Snapshot pair information is changed.
Creating Pairs that Belong to a Group
To create multiple SnapShot pairs that belong to a group:
1. Create the first pair that belongs to a group specifying an unused group
number for the new group with the –gno option. The new group has
been created and in this group, the new pair has been created too. Refer
to the following example.
2. Add the name to the group if necessary using command to change the
pair information. Refer to the following example.
3. Create the next pair that belongs to the created group specifying the
number of the created group with –gno option.
SnapShot pairs that share the same P-VOL must use same Data Pool.
4. By repeating the step 3, the multiple pairs that belong to the same group
can be created.
% aureplicationlocal –unit subsystem-name –ss –chg –pace slow
–pvol 200 –svol 1001
Are you sure you want to change pair information?
(y/n[n]): y
The pair information has been changed successfully.
%
% aureplicationlocal –unit subsystem-name –ss –create –pvol 200
–svol 1001 –gno 20
Are you sure you want to create pair “SS_LU0200_LU1001”?
(y/n[n]): y
The pair has been created successfully.
%
% aureplicationlocal –unit subsystem-name –ss –chg –gno 20 –pvol
200 –svol 1001
-newgname group-name
Are you sure you want to change pair information?
(y/n[n]): y
The pair information has been changed successfully.
%