Filter
Top Products
22 301C User Manual M-510324
Honeywell 7/10
System Programming
Programming Interface
System Programming
The system’s Normal programming mode offers several menu options
that are accessible from the main menu screen:
Tx Info: Allows transmitter parameters to be programmed
Groups: Allows groups of transmitters to be set up
Events: Allows events and event behavior to be programmed
Acqui: Allows the datalogging feature to be activated or deactivated
Copy: Allows data or parameters to be copied from the (controller)
configuration to parameters
Config: Allows system parameters and password to be set
Network: Allows actions on the network to be performed,
communication statistics to be consulted, and remote
calibrations to be performed
Tests: Allows each device to be tested sequentially (inputs, outputs,
communications, events, etc.) and operation of various
parameters to be validated
BACNet: Allows a device’s BACNet parameters to be set
Wireless: Allows a network of wireless gas detection devices to be
configured, monitored, and modified.
Note: Access to the programming functions is password protected.
The default password is 2967.
The screen display shown below appears initially. This display can be
configured to scroll among the information screens for each device
connected to the controller.
If one or more of the connected devices is in an alarm mode, the
controller will only scroll between the main information screen and the
screens for device(s) in alarm mode. In this case, you must scroll
manually to view screens for other devices.
VA301C Ver. 3.00
Ad: 1 Gr:0 Ev:0
2007-01-17 13:18:18