Filter
Top Products
27
SCANNER OPERATION
IR ACTIVATION AREA (IR LED OUTPUT)
The StratosH’’s default power save mode
†
is Dual Action Power Save Mode #2 (see page 32). This power save mode
†
turns
the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals. Any movement
detected by the IR in the activation area, shown below, will cause the scanner to exit the power save mode. The motor will
restart automatically and the laser will turn back on preparing the scanner for bar code recognition, decoding and transmission.
Figure 30. IR Activation Area Perpendicular to Package Flow (IR LED Output)
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.
Specifications are subject to change without notice
.