Filter
Top Products
8. Press <Enter> for Setup Mode
9. The following screen should appear.
10. Your Choice? Enter 0 for server configuration.
11. IP Address: (000) XXX.XXX.XXX.XXX <Enter>
12. Set Gateway IP Address
Type Y, if a gateway is needed. XXX.XXX.XXX.XXX
(Gateway Address) Type N, if a gateway is not needed
This number may or may not be needed. Check with the
MIS department to verify if the Ethernet Card will need a
gateway programmed.
13. Netmask: Number of Bits for Host Part (0=default to Class C)
(00) Type 8, 16, or 24 depending on the subnet mask class
being used.
Class A: 24 = subnet of 255.0.0.0
Class B: 16 = subnet of 255.255.0.0
Class C: 8 = subnet of 255.255.255.0
14. Change Telnet Config Password (N) <Enter>
No password needed.
15. Main Menu Screen Appears.
Your Choice?
Type "1" <Enter> for Channel 1 configuration
16. Baud Rate=38400 <Enter>
17. I/F Mode is not needed just hit <Enter>
18. Flow=02 <Enter> (Flow Control Enabled)