Filter
Top Products
NOTICE
Any use of this product is subject to the terms and acceptance of
the Engineering Systems Software Agreement. Please request a
copy from Engineering Systems, and review the agreement
carefully.
D
ISCLAIMER
Product Liability; Mutual Indemnification
In the event that a Customer receives a claim that a Product or
any component thereof has caused personal injury or damage to
property of others, Customer shall immediately notify Engineering
Systems in writing of all such claims. Engineering Systems shall
defend or settle such claims and shall indemnify and hold
Customer harmless for any costs or damages including reasonable
attorneys fees which Customer may be required to pay as a result
of the defective Product or the negligence of Engineering Systems,
its agents, or its employees. Customer shall hold harmless and
indemnify Engineering Systems from and against all claims,
demands, losses and liability arising out of damage to property or
injury to persons occasioned by or in connection with the acts or
omissions of Customer and its agents and employees, and from
and against all claims, demands, losses and liability for costs of
fees, including reasonable attorneys fees, in connection therewith.
UNPACKING PROCEDURE
CAUTION
If any damage to the shipment is noticed before unpacking, a claim
must be filed with the commercial carrier.
All containers should be opened and unpacked carefully in order to
prevent damage to the contents.
The following steps are used to unpack equipment in preparation
for installation:
1. Open the container and remove the unit(s) and all packing
material. Retain the container and all packing materials. They
may be used again for reshipment of the equipment, if needed.
2. Inspect the contents for shortage. If items are missing items,
contact the order entry department at 800-323-4576.
3. Visually check contents. If damage is discovered, perform the
following: