Filter
Top Products
1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and
automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you must
install a device driver to enable the operating system to address the controllers. For
device drivers and information about configuring the Ethernet controllers, see the
Broadcom NetXtreme Gigabit Ethernet Software CD that comes with the server. For
updated information about configuring the controllers, go to
http://www.ibm.com/support/.
Using the baseboard management controller
The baseboard management controller provides environmental monitoring for the
server. If environmental conditions exceed thresholds or if system components fail,
the baseboard management controller lights LEDs to help you diagnose the
problem and also records the error in the System Event/Error log.
The baseboard management controller also provides the following remote server
management capabilities through the OSA SMBridge management utility program:
v Command-line interface (IPMI Shell)
The command-line interface provides direct access to server management
functions through the IPMI 1.5 protocol. Use the command-line interface to issue
commands to control the server power, view system information, and identify the
server. You can also save one or more commands as a text file and run the file
as a script.
v Serial over LAN
Establish a Serial over LAN (SOL) connection to manage servers from a remote
location. You can remotely view and change the BIOS settings, restart the server,
identify the server, and perform other management functions. Any standard
Telenet client application can access the SOL connection.
Enabling and configuring SOL using the OSA SMBridge management
utility program
To enable and configure the server for SOL by using the OSA SMBridge
management utility program, you must update and configure the BIOS code and
enable the operating system for an SOL connection.
Note: In an SOL session, use the following commands instead of function keys:
v To start the Configuration/Setup Utility program when the prompt Press F1
for Configuration/Setup appears, press Esc, Shift+o, then Shift+p.
v To start the diagnostic programs, when the prompt F2 for Diagnostics
appears, press Esc, Shift+o, then Shift+q.
BIOS update and configuration
Complete the following steps to update and configure the BIOS code to enable
SOL:
1. Update the BIOS code:
a. Download the latest version of the BIOS code from
http://www.ibm.com/support/.
b. Update the BIOS code, following the instructions that come with the update
file that you downloaded.
2.
Configure the BIOS settings:
Chapter 2. Configuring the server 23