Filter
Top Products
The
PPP
Settings
window
opens,
as
shown
in
the
following
illustration.
Note:
The
values
in
the
window
are
only
examples;
your
settings
might
be
different.
4.
Use
the
arrow
keys
to
navigate
to
each
field.
Verify
the
values
in
the
following
fields:
Network
Interface
The
default
is
Disabled.
Change
this
field
to
Enabled.
IP
Address
The
default
value
is
192.96.1.1.
You
can
use
the
default
value
or
another
value,
but
the
server
must
be
able
to
establish
a
connection
to
that
address.
The
default
IP
address
(local
and
remote)
is
easily
reconfigurable.
Subnet
Mask
The
default
value
is
255.255.255.255.
Line
Type
The
value
is
set
to
PPP.
Remote
IP
Address
The
default
value
is
192.96.1.2.
Authentication
Protocol
The
default
is
CHAP
then
PAP.
Make
sure
that
the
value
in
this
field
matches
your
client
settings.
For
detailed
information
about
the
PPP
settings,
see
the
information
about
configuring
PPP
access
over
a
management
port
in
the
Remote
Supervisor
Adapter
User’s
Guide
on
the
IBM
xSeries
Documentation
CD.
5.
Press
F6
to
apply
the
changes.
6.
Press
Esc.
After
the
Warning
window
opens,
press
Enter
to
restart
the
Remote
Supervisor
Adapter.
Figure
24.
Ethernet
Settings
window
setting
up
point-to-point
protocol
60
xSeries
445
Type
8870:
User’s
Guide