Filter
Top Products
CIO-DIO48H User's Guide Installing the CIO-DIO48H
Disregard the numbers printed on the switch
When setting the base address, refer to the numbers printed in white on the printed circuit board.
PC I/O Address Summary
Hex Range Function Hex Range Function
000-00F 8237 DMA #1 2C0-2CF EGA
020-021 8259 PIC #1 2D0-2DF EGA
040-043 8253 TIMER 2E0-2E7 GPIB (AT)
060-063 8255 PPI (XT) 2E8-2EF SERIAL PORT
060-064 8742 CONTROLLER (AT) 2F8-2FF SERIAL PORT
070-071 CMOS RAM & NMI MASK (AT) 300-30F PROTOTYPE CARD
080-08F DMA PAGE REGISTERS 310-31F PROTOTYPE CARD
0A0-0A1 8259 PIC #2 (AT) 320-32F HARD DISK (XT)
0A0-0AF NMI MASK (XT) 378-37F PARALLEL PRINTER
0C0-0DF 8237 #2 (AT) 380-38F SDLC
0F0-0FF 80287 NUMERIC CO-P (AT) 3A0-3AF SDLC
1F0-1FF HARD DISK (AT) 3B0-3BB MDA
200-20F GAME CONTROL 3BC-3BF PARALLEL PRINTER
210-21F EXPANSION UNIT (XT) 3C0-3CF EGA
238-23B BUS MOUSE 3D0-3DF CGA
23C-23F ALT BUS MOUSE 3E8-3EF SERIAL PORT
270-27F PARALLEL PRINTER 3F0-3F7 FLOPPY DISK
2B0-2BF EGA 3F8-3FF SERIAL PORT
You can set the base address switch to any address in the range of 000-3F8. If you are not using IBM
prototyping cards or another board which occupies these addresses, 300-31Fh are also free to use.
Addresses not specifically listed, such as 390-39Fh, are not reserved and may be available. Check your
computer for other boards which may use I/O addresses.
Installing the CIO-DIO48H
After you configure the base address, you can install the CIO-DIO48H into your computer. Follow the steps
below.
Install the MCC DAQ software before you install your board
The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install
the MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on
installing the software.
1.
2.
3.
Turn your computer off, open it up, and insert your board into an available ISA slot.
Close your computer and turn it on.
To test your installation and configure your board, run the InstaCal utility you installed in the previous
section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-
Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.
10