Filter
Top Products
EM78M611E
Universal Serial Bus Series Microcontroller
Product Specification (V1.11) 04.20.2007
•
••
• 23
(This specification is subject to change without further notice)
8.5.2 Device Address and Endpoints
EM78M611E supports one device address and three endpoints, EP0 for control
endpoint, EP1 and EP2 for interrupt endpoint. Sending data to USB host in
EM78M611E is very easy. Just write data into EP’s FIFO, then set flag, and the UDC
will handle the rest. It will then confirm that the USB host has received the correct data
from EM78M611E.
8.6 Reset
The EM78M611E provides three types of reset: (1) Power-on Reset, (2) Watchdog
Reset, and (3) USB Reset.
8.6.1 Power-on Reset
Power-on Reset occurs when the device is attached to power and a reset signal is
initiated. The signal will last until the MCU becomes stable. After a Power-on Reset,
the MCU enters into the following predetermined states (see below), and then, it is
ready to execute the program.
a. The program counter is cleared.
b. The TCC timer and Watchdog timer are cleared.
c. Special registers and Special Control registers are all set to their initial values.
8.6.2 Watchdog Reset
When the Watchdog timer overflows, it causes the Watchdog to reset. After it resets,
the program is executed from the beginning and some registers will be reset. The UDC
however, remains unaffected.
8.6.3 USB Reset
When the UDC detects a USB Reset signal on the USB Bus, an MCU interrupt occurs,
after which it proceeds to perform the specified process that follows. After a USB
device is attached to the USB port, it cannot respond to any bus transactions until it
receives a USB Reset signal from the bus.
8.7 Saving Power Mode
The EM78M611E provides two options of power-saving modes for energy conservation,
i.e., Power Down mode and Dual clock mode.
8.7.1 Power Down Mode
The EM78M611E enters into Power Down mode by clearing the RUN register
(IOCE[4]). During this mode, the oscillator is turned off and the MCU goes to sleep. It
will wake up when signal from USB host is resumed, or when a Watchdog reset occurs
or when an input port state changes.
If the MCU wakes up when I/O port status changes, the direction of the I/O port should
be set at input direction, and then read the state of port. For example: