IBM ETX-DB-ATX Computer Hardware User Manual


 
ETX-DB-ATX
ETX MODULE BASEBOARD
PCB V1.2
Manual Revision 1.0
April 11, 2002
Copyright 2003 by ICP Electronics Inc. All Rights Reserved.
The information in this document is subject to change without prior notice in order to
improve reliability, design and function and does not represent a commitment on the part
of the manufacturer.
In no event will the manufacturer be liable for direct, indirect, special, incidental, or
consequential damages arising out of the use or inability to use the product or
documentation, even if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are
reserved. No part of this manual may be reproduced by any mechanical, electronic, or
other means in any form without prior written permission of the manufacturer.
Trademarks
ETX-DB-ATX is a registered trademark of ICP Electronics Inc. IBM PC is a registered
trademark of International Business Machines Corporation. Intel is a registered
trademark of Intel Corporation. Other product names mentioned herein are used for
identification purposes only and may be trademarks and/or registered trademarks of their
respective companies
ETX-DB-ATX
2
Contents
1. Introduction .........................................................................4
1.1 Specifications.............................................................................4
1.2 What You Have ..........................................................................5
2. Installation ...........................................................................6
2.1 ETX-DB-ATX Board Layout.......................................................6
2.2 Unpacking Precautions .............................................................8
2.3 LCD Vcc Voltage Selector .........................................................8
2.4 Clear CMOS Setup....................................................................8
2.5 WatchDog Timeout Active Selector...........................................9
2.6 Internal Buzzer Enable/Disable.................................................9
2.7 Ethernet Controller Setting ........................................................9
3. Connection ........................................................................10
3.1 ETX Connector X1...................................................................10
3.2 ETX Connector X2................................................................... 11
3.3 ETX Connector X3...................................................................12
3.4 ETX Connector X4...................................................................13
3.5 Floppy Disk Drive Connector ..................................................14
3.6 PCI E-IDE Disk Drive Connector.............................................15
3.7 Parallel Port .............................................................................16
3.8 Serial Ports ..............................................................................16
3.9 USB Port Connector ................................................................17
3.10 IrDA Infrared Interface Port ...................................................18
3.11 TV-OUT Interface Port ...........................................................18
3.12 VGA Connector......................................................................18
3.13 LCD/LVDS Interface Connector ............................................19
3.14 LAN RJ45 Connector ............................................................19
3.15 AUDIO JACK .........................................................................20