IBM R50p Series Laptop User Manual


 
Symptom or error FRU or action, in sequence
0182
Bad
CRC2. Enter BIOS Setup
and load Setup defaults.—The
checksum of the CRS2 setting
in the EEPROM is not correct.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save the
current setting by
pressing F10.
2. System board.
0185
Bad
startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save the
current setting by
pressing F10.
0187
EAIA
data access error—The
access to EEPROM is failed.
System board.
0188
Invalid
RFID Serialization
Information Area.
System board.
0189
Invalid
RFID configuration
information area—The
EEPROM checksum is not
correct.
System board.
0190
Critical
low-battery error
1. Charge the battery pack.
2. Battery pack.
0191
System
Security—Invalid
Remote Change requested.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
0192
System
Security—IBM
Embedded Security hardware
tamper detected.
System board.
0199
System
Security—IBM Security
password retry count exceeded.
1. Run IBM BIOS Setup
Utility, and then save the
current setting by
pressing F10.
2. System board.
01C8
Two
or more modem devices
are found. Remove all but one
of them. Press <Esc> to
continue.
1. Remove either a Mini-PCI
Card or a modem
daughter card. Otherwise,
press Esc to ignore the
warning message.
2. System board.
01C9
More
than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
Symptom-to-FRU index
ThinkPad R50/R50p and R51 Series 55