Filter
Top Products
16
FOR YOUR REFERENCE (Continued)
About audio
When the transceiver is connected to a PC with the USB cable (third party), the following operations can be
performed;
• Received audio output to the PC.
• Modulation input from the PC.
The set mode item ‘Modulation input (Data OFF)’ or ‘Modulation input (Data ON)’ must be set as “U” (USB) for
modulation input from the PC.
See p. 17 on this installation guide or p. 77 on the IC-7200 instruction manual for details of settings.
[Received audio output to the PC]
The received audio output format
The received audio output format from the USB jack is listed as below.
The received audio output
The number of data bit 16-bit
Sampling rate* 8/11.025/16/22.05/32/44.1/48 kHz
The number of channel
Monaural (Stereo: The same audio signals are output from both L/R.)
* The sampling rate other than those above can be used according to the application.
The received audio output
The same audio signals are output from the USB jack and the ACC socket.
• The received audio is always output regardless of the squelch condition (open/close).
(The beep tones and the voice synthesizer announcements are not output).
• The received audio output level cannot be adjusted with the [AF] control.
Operating mode
The modulation input can be used when SSB (LSB/USB), SSB data (LSBD/USBD), AM and AM data (AMD)
mode is in use.