Filter
Top Products
9
The displayed dialogue boxes, indications or oper-
ations may differ slightly from the following instruc-
tions according to your system conditions or envi-
ronment.
q
Make sure that the transceiver is not connected to
the PC.
w Start up Windows.
• Quit all other application if running.
e Connect the transceiver to the PC with the USB
cable (third party) as shown below.
• Be sure to connect the USB cable correctly and not up-
side down.
Transceiver
PC
USB cable
(third party)
To USB jack
To USB port
Type A
Type B
ACC
KEY SEND ALC
REMOTE
r Turn the the transceiver power ON.
• “Found New Hardware” appears as below.
t The “Found New Hardware Wizard” will come up as
below.
Click [Next>].
Click
y Select “Search for a suitable driver for my device
(recommended),” then click [Next>].
Click
Select
u Select “Specify a location,” then click [Next>].
Click
Select
i Click [Browse...].
Click
Windows 2000
DRIVER INSTALLATION (Continued)
NOTE:
BE SURE to connect the transceiver to the PC with the USB cable (third party) before installing the USB
driver.
☞ Continues to the next page