Filter
Top Products
Even when disconnected, the mobile device and the keyboard remain
bonded. The keyboard will only reconnect to the bonded mobile device and
the mobile device will only listen to the bonded keyboard. To break the bond
press <Ctrl> <Left Fn> <Right Fn> for approximately 1 second or until
the green LED flashes quickly. Normally the bond will not need to be broken
unless the keyboard will be used with another mobile device or another
keyboard will be used with the mobile device. Therefore, please avoid
pressing <Ctrl> <Left Fn> <Right Fn> during normal operation. If this
has happened, you will have to establish a new connection as described in
the Configuring the Keyboard to your Device section above.
NOTE: Do not press <Ctrl> <Left Fn>
<Right Fn> together. This will break the bond
between the keyboard and the mobile device.
If this happens, you will have to establish a
new connection as described above.
Automatic Reconnection from Waiting Mode
Some mobile devices have more restrictive Bluetooth settings than others, in
terms of the type of operating mode, or the type of paired device the
software will allow reconnection with from waiting mode. If your Stowaway
keyboard software returns to waiting mode, tapping any key on the
keyboard will not trigger automatic reconnection in certain circumstances.
This may be because the settings in the Bluetooth stack on your mobile
device have restricted reconnection from devices that are not Authorized,
or that the Bluetooth Auto operation mode selection disallows reconnecting.
If you encounter problems auto-reconnecting from BT Waiting for
keystrokes mode, you will want to review Bluetooth Help for specifics on
Bluetooth connectivity for your mobile device.
Stowaway Ultra-Slim Owner’s Manual for Symbian UIQ
Page 11