InFocus IN3926 Projector User Manual


 
12
Shutting down the projector
Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the
projector off after no active sources are detected and no user interaction with the
projector is performed for 30 minutes. By default, this feature is off. You can
change the length of time, see page 29.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp
turns off and the Power LED blinks blue for 1 minute while the fans continue to run
to cool the lamp. If the Power Saving Mode feature is on and when the lamp has
cooled, the LED lights blue and the fans stop. If the Power Saving Mode feature is
off and when the lamp has cooled, the LED blinks blue and the fans stop. Unplug
the power cable to completely power off the projector.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section. If it does not,
troubleshoot the setup.
The Status Indicator Panel on top of the projec
tor indicates the state of the projector
and can help you troubleshoot.
Table 3: Status indicator light behavior and meaning
Status Indicator Light Meaning
POWER: Solid blue
POWER: Blinking blue
1. If the Power Saving Mode feature is on,
the projector is plugged in.
2. The projector is on and initialized.
3. The projector is in normal operation.
1. If the Power Saving Mode is off, the
p
rojector is plugged in.
2. The projector is powering down and the
f
ans are cooling the projector.
POWER: Blinking blue
TEMP: Blinking red
LAMP: Blinking red
POWER: Solid blue
TEMP: Blinking red
LAMP: Blinking red
The projector fan(s) are not operating
corre
ctly and the projector has been shut
down.
The lamp failed to ignite.
Contact Technical Support if the problem
pe
rsists. Visit www.infocus.com/support to
contact service.
POWER: Solid blue
TEMP: Off
LAMP: Blinking red
The lamp has reached its end of life and
must be r
eplaced. The lamp will continue
to operate until it fails.
Contact Technical Support. Repair may be
ne
eded.
POWER: Solid blue
TEMP: Blinking red
LAMP: Off
1. The projector is overheating and the
lamp
will be shut off. The fans will
continue to run.
2. The projector will not turn back on until
the cooli
ng process is complete.