Filter
Top Products
ISSUED: 10-22-04 SHEET #: 055-9236-5 01-10-06
Visit the InFocus Web Site at www.infocus.com
4 of 11
Drill two 1/4" (6 mm) dia. holes to a minimum depth of
2.5" (64 mm). Attach ceiling plate (Q) using two
concrete anchors (G) and #14 x 2.5" wood screws (F)
as shown in Illustration A and 1, 2, and 3. Tighten all
fasteners.
Skip to step 7.
F
Illustration A
Installation to Concrete Ceilings
Alligator
®
concrete anchors are recommended.
Q
1
3
Drill hole and insert anchor.
concrete
ceiling
F
F
2
Q
CUTAWAY VIEW
CONCRETE CEILING
• Concrete anchors are not intended for attachment to
concrete wall covered with a layer of plaster, drywall,
or other finishing material. If mounting to concrete wall
covered with plaster/drywall is unavoidable, plaster/
drywall (up to 5/8" thick) must be counterbored as
shown below. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by installer.
WARNING
G
• Make sure that the supporting surface will safely
support the combined load of the equipment and all
attached hardware and components.
• Tighten concrete anchor bolt firmly, but do not over-
tighten. Overtightening can damage the bolt, greatly
reducing its holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
G
G
G
Place ceiling plate over anchor and secure with screw.
After repeating step one tighten all fasteners.
INCORRECT
concrete
metal
bracket
plaster/
dry wall
CORRECT
concrete
metal
bracket
plaster/
dry wall